![]() ![]() So I decided to take a look at /usr/sbin/fancontrol to see why. This causes the error Configuration is too old, please run pwmconfig again Due to motherboard limitations, my sensors are defined as absolute paths. When starting fancontrol via #service fancontrol start or #fancontrol, the errors of /usr/sbin/fancontrol are not printed. ![]() Also, many thanks to for advice and pointing me in the right direction. Here is the answer just incase I mess this up or anyone else has the same problem. I feel silly, should've investigated more. Start-stop-daemon -stop -quiet -pidfile $PIDFILE -oknodo -startas $DAEMON Log_warning_msg "Not starting fancontrol run pwmconfig first." Log_failure_msg "Not starting fancontrol, broken configuration file please re-run pwmconfig." Start-stop-daemon -start -quiet -background -pidfile $PIDFILE -startas $DAEMON If $DAEMON -check 1>/dev/null 2>/dev/null then What is the difference between starting fancontrol as a service vs manually that would cause it to fail? Starting fan speed regulator: fancontrol. ![]() However when starting fancontrol as a service (at or after boot), it fails. Settings for /sys/devices/platform/it87.656/hwmon/hwmon]*/device/pwm3:Ĭontrols /sys/devices/platform/it87.656/hwmon/hwmon]*/device/fan2_input Loading configuration from /etc/fancontrol. When fancontrol is started from the terminal it works fine # fancontrol ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |